The cogeneration unit is open skid mounted type, driven by MAN Engine E3262LE202, coupled with Leroy Somer alternators and Motortech all-in-one CHP control system, fueled by landfill biogas through desulfurization & pre-treatment device, generating electricity & hot water simultaneously, with electrical efficiency 38.8%, heat effi 48.3% and total efficiency 87.1%...

The gas power plant consist in 6×1200KW 6.3KV engine generators working in parallel, modularized container generation stations for outdoor application, running in island mode to supply non-stop electricity to loads equipments. Due to hard operations conditions, the genset is with specially designed Air Inlet System against dusty environment and IP44 Protections Level…

Typical WtE projects, the gas power plant consist in 2×1560KW MWM gas engine CHPs working in parallel, containerized CHP units, driven by the most optimum efficiency engine of TCG2020V16/CG170-16, with electrical Eff 41.8%, Heat Eff 44% and total Eff 85.8%. The units are synchronized with mains grid and export energy at government sponsored rates…

This is a typical Waste to Energy project, two phases cogeneration plant, by using biogas produced from diary farm. The first phase are 2×800kW MWM Intelligent CHPs working in parallel (gas engine TCG3016V16C). The second phase are 2×560kW MAN Intelligent CHPs running in parallel (gas engine E3262LE202), synchronized with mains grid and export energy.

The gas cogeneration plant, located in Nigeria, is formed by 6×600kw modular containerized engine generators CHP, for totally two sites, each site with 3 gensets units. The gas fuel is oilfield APG at MN 79, with specially designed cooling system & IP44 protection level, generating electricity to drive loads on site, while produce hot water for plant internal use.

The biogas power generator plant, located in Guangzhou, China, is formed by 4x1000kW generator sets, the gen sets type is low noise modularized container biogas engine generating unit, with special configuration of intelligent closed loop control, the gensets with synchronization parallel control ComAp IG-NT, working export energy to mains Grid...

The biogas generator & CCHP power plant consist in 3×800KW MWM gas engine working in parallel, containerized Cogeneration units, with merits of Optimum Efficiency, Full Turbo power and High Reliability, with electrical effi 42.8%, Heat Effi 42.3%,total Efficiency 85.1%, Generate Hot Water to Heat Digester & Generate Cooling for Refrigeration for Cattle Farm Dormitory,

Biogas Power Station , 4×200kW & 2X500kW Cummins Series soundproof gas generators working in parallel to drive loads for Farm's Equipments, driven by engine NTA855 & KTA38 Series, coupled with Leroy Somer alternator & world top gas engine control system like Swiss Huegli Governing actuator, Germany Motortech throttle valve & USA Altronic ignition system.

Gas fuel is LFG (landfill gas), ETTES Typical Project of WtE, total plant capacity is 2400kW, composed by 2 units of MWM 1.2MW Trigenerations driven by Gas Engine TCG2020V12, Electric efficiency 43.4%, Heat Efficiency 43.2% & Total Efficiency 86.6%, generation of electricity, hot water & cooling water for multiple applications. Emissions level is NOx≤82mg/m3 after SCR.

The gas power station project is generate electricity to drive oil-drilling devices on site, gas fuel is APG (oilfield associated petroleum gas). 16x1200kw working in parallel, the actual output is 16MW due to sub-quality of gas conditions. Gas engine is CNPC 190 series H16V190ZLT, main components of gas control system are from Motortech Germany ...